How To Unclog A Toilet When Nothing Works?

0
68
How To Unclog A Toilet When Nothing Works

Consider waking up with a good attitude and going to the toilet to begin your day. The sight of water rising to the lip of your toilet and slowly falling over onto your bathroom floor might be frightening. Adulthood carries with its dozens of new puzzling and anxiety-inducing responsibilities that you would never have imagined were so important until they were in front of you. Unclogging a toilet is undoubtedly one of these tasks. It might lead you to the questions like how to unclog a toilet when nothing works?

How to do it by yourself?  Toilet blockages usually seem to occur at inopportune times. After conducting some research, we’ve come up with a few ideas for unclogging toilets when nothing else appears to work.

What Cause Clogged Toilet?

Clogged toilets are dirty, unsightly, and horrible to clean. If this problem persists, you must determine its fundamental cause—your toilet clogs for various reasons, some obvious and some less so. The following are some of the most typical reasons for blocked toilets:

  • You may have flushed too much toilet paper as the first cause. All that paper gets forced down the drain in a soggy, claggy mass. Because the drain narrows as waste material exits the toilet bowl, it gets compressed into a narrower channel.
  • The toilet vent is restricted or blocked. The air vent on your roof getting clogged is a typical source of clogging. Birds enjoy building nests, which limits the amount of fresh air in the ventilation system. If you observe a decrease in pressure and a weaker flush, your vent might be to blame.
  • Hair, paper, and strange things have plugged your drainpipe. Or it may become clogged due to feces accumulation in the piping.
  • You flushed something that shouldn’t get flushed
  • External factors might occasionally affect how effectively your toilet performs. Tree roots can clog your bathroom because they obstruct the smooth movement of waste matter to the sewers, causing everything to back up.

How to Unclog A Toilet When Nothing Works?

Now let’s jump to the primary query without any delay, i.e., how to unclog a toilet when nothing works? A persistent toilet blockage might catch you off guard. When this occurs, it’s critical to understand which treatments are most effective in removing it. The following are tried-and-true procedures, listed in order of difficulty, that have helped many poor people.

Plunger

While this equipment may look, it is the most effective method of unclogging a toilet. Plungers can get used in both directions. They can pump water down the pipe to break up the clog and produce much suction in the opposite direction to draw the blockage back to the surface. Following are the simple steps while using a plunger: 

  • The first thing you should do is put on rubber gloves to protect your hands from toilet water splashing.
  • Then, grip the plunger by the handle and push the rubber piece of the plunger into the toilet bowl until an airtight vacuum gets achieved.
  • Then, steadily increase the force with which you press down the plunger.
  • Continue repeating this until you obtain a tighter vacuum, then remove the plunger.

Hot Water and Dish Soap

Oddly, one of the most efficient techniques of how to unclog a toilet when nothing works might be there in front of you, and you’re not even aware of it.

While a gallon of hot water is boiling up on the stove, throw some dish soap into your toilet. When the water is boiling but not boiling, cautiously pour it into the bathroom. Allow the dish soap and hot water to soften the blockage for 10-15 minutes. This straightforward approach loosens the blockage, allowing the toilet line to be free of any obstruction.

Baking Soda and Vinegar

These are kitchen goods but believe us when we say they are equally helpful outside of the kitchen. A baking soda and vinegar combination may remedy the problem if a plunger isn’t working. When nothing else works, it’s a simple and inexpensive solution to unclog a toilet.

To begin, make a 1:2 mixture of baking soda and water. Pour this into the toilet bowl, then add two glasses of vinegar. Vinegar and baking soda often react to generate bubbles, so pour cautiously and gently to avoid overflowing or spilling toilet water. Allow for a few minutes for the baking soda and vinegar solution to work.

Plumbing Snake – Toilet Auger

You should consider acquiring a plumbing snake if you don’t already have one. If a plunger and the tried-and-true combination of baking soda and vinegar don’t work, you’ll have to hope and pray that a plumbing snake will.

  • Wear rubber gloves beforehand if you don’t want to get some unpleasant water splashes from your toilet.
  • When everything is ready, insert one end of the plumbing snake into your toilet and push it down until resistance gets felt.
  • You may twist the closet auger farther to drive the blockage into the drain. Continue pressing until you feel nothing is blocking your way to release the water completely.
  • If there is no longer an obstruction, flush the toilet and note how quickly the water runs. If the flow is quicker, there is no longer an obstacle.

When to Call the Plumber for a Clogged Toilet?

If none of the above solutions fix your blocked toilet problem, you may need to hire a certified and expert plumber. In rare situations, the problem may require the removal of the complete toilet. Since you are unlikely to have the necessary tools or knowledge, calling a plumber is the best option.

Final Thoughts

Toilets silt up on their own over time. When a bathroom becomes blocked, flushing it can be a significant issue. Fortunately, using the steps presented to unclog a toilet when nothing else works, you may rapidly restore your system to proper usage. However, if everything else fails, call a plumber to inspect the situation. Usual, and you’ll have a better flush.

 

More on ExpressThinker.com: What is the best treadmill for a home under $500? Read here.

LEAVE A REPLY

Please enter your comment!
Please enter your name here